Applying the plumber's joint tape around the pipe fittings will help prevent leaks. The drain trap assembly will include: drain trap, tail piece, drain extension, and other smaller components.Preventative measures such as using a bacterial enzyme will help keep the pipes clean and odour free. If the trap has a cleanout plug on bottom of curved section, use the wrench to remove it. When you know the steps involved with replacing a drain tap, it is not that difficult to do. As well, it is important to maintain your water and sewer lines to prevent clogs. Keep the trap upright as you remove it.When you purchase a drain trap, it will include a number of components.It is essential for your health and safety to make sure drain traps are kept in good working order so there are no sewage gas leaks.

Drain trap kits can be used for almost all installation projects and are available at plumbing supply stores and department stores. Drains must be kept in good condition so they work properly, however, these traps can eventually become worn, damaged, and clogged. Make sure you wait until the water has flowed out. If not, unscrew the slip nuts and move them to the side. The water will flow 2-1/2" upvc 45 degree plastic elbow pipe fitting out into the buck that you have positioned underneath. Whatever the reason, a damaged and malfunctioning drain trap should be immediately repaired.To replace it, you will need the following tools: bucket, wrench, screwdriver, new replacement trap, and plumber's joint compound or tape. Make sure the slip nuts, washers, and compressions are properly aligned.

The drain trap is important as it provides a seal to prevent the leak of harmful gases. Use a wrench to carefully remove the trap. Make sure all connections are tight and secure.4. You have the option of using plumber's joint tape or compound to help with securing connections.A drain trap is located under the drain of sinks and toilets. Remove the tailpiece and unscrew the trap from the drainpipe. When this happens, it can require replacing the traps. The pieces are fragile so it is important to handle them with care. Before you start the repair, turn off the home water supply or the water that travels to the pipe where you will be replacing the drain trap.

Once you have completely removed the old trap, you can begin to insert the new one. Leakage and seepage of sewer lines are not always detected right away, so it is important to check your traps to make sure they are still in proper working order. Below are the steps involved with replacing a drain trap:1. Once you have secured all connections, washers, joints, and other fittings, you should turn the water back on and run it to make sure there are no leaks and to fill the trap with water so that there is an effective barrier against sewage gases. There should be directions that come with the newly purchased trap.